TSC-1
The TSC-1 timer is a 24 hr. time switch that provides accurate timing with 96 non detachable trippers for On/Off functions adjustable in 15 Min. increments up to 48 cycles per day. Easy to set and operate. The heavy plastic enclosure and aluminum back plate provide a durable and attractive housing which will never corrode or discolor from hot, cold or humid environments. This unit can be used independently or as part of a combination of control devices to coordinate numerous system functions. Precision synchronous clock motor provides 15 amp 110V control for pumps, fans lighting, solenoids, motors relays or virtually any equipment or appliance dependent upon multiple daily operations. |
|
Plug the power cord into 110 V outlet. Plug equipment into the power cord piggy back receptacle. Do not exceed power ratings of wall outlet or electrical service. High amperage relays are available for heavy draw applications. Turn clock dial to current time of day. AM and PM is indicated by colored ring on dial face. Push the trippers toward the center of the dial for "On" times and leave in the outward position for "Off" periods. The On\Off functions may be as frequent as every 15 minutes.
| In this example the TSC-1 TimeStat is operating supplemental lighting to function during desired hours. This diagram is operating a light but it could just as well be almost any 120 volt appliance. The TimeStat is capable of switching a 15A load. |
|
| The application example shows the TSG-1 TimeStat triggering an HAR-1 power relay to switch the high power loads of multiple lighting (or exhaust fans). The TimeStat operates on 110V, however the HAR-1 enables it to switch up to 30A of either 110 or 240V power supplies. | ![]() |
|
Open PDF of TSC-1 Instructions in French and English
COMBINATION POWER-CORD
All Control Stats utilize a duplex cord-cap which provides a combination plug and receptacle power cord design. Insert plug into 110V wall outlet and plug equipment into piggy back receptacle.
